PCB Fabrication quote PCB Assembly quote Free passive parts
 

Pin-in-Paste Reflow Calculations and Special Cases

The major concern of the pin-in-paste reflow process is the quality of the solder joint. It must meet IPC610 standard. The criteria for IPC610, class 2 are:
  1. Both sides of the wire leads must obtain at least a 75% solder coverage
  2. Air cavities should be less than 30%
  3. The surface of the drilling as well as the component’s lead must have 100% wetting.
To meet the above requirements, the following steps need to be considered:
  1. Solder alloy volume calculation
  2. The volume between the hole and pin (Vsolder >= V hole + V fillet – V pin) should be filled up by the solder alloy with good fillet.
  3. Minimum applied paste volume calculation
  4. Solder paste contains about 50% of metal material and 50% additional material (flux) which oozes out during the reflow process. So the minimum paste volume requirement is:
    V paste = 2 x Vsolder = 2 x (Vhole + V fillet – Vpin)
  5. Stencil aperture oversize design
  6. The area of the aperture is calculated as follows:
    Apaste = Vpaste / Stencil (where the Stencil = the stencil thickness.)
    The Stencil aperture size is calculated as follows:
    If it is a circle, then the Dstencil = 2 x SQRT(Apaste / π ) , where Dstencil is aperture diameter.
    If it is square, then the Lstencil = SQRT(Apaste ), where the Lstencil is the aperture length.
    If it is rectangle, then Apaste = Lstencil x Wstencil, where the Lstencil is the aperture length and Wstencil is its width.
    In most of situations, the aperture size will be bigger than pad’s size. This means that the solder paste will cover or extend over the entire hole.
  7. Double Stroke: Special Paste Printing
  8. To get enough paste into the hole, double stroke is an acceptable process when the right pressure is applied. The squeegee print speed should be adjusted at a slower rate to let the paste fill the apertures more completely. This causes more solder paste to be deposited.
 
Bittele Offered Technical Expertise to Attendees at IPC APEX EXPO 2016
Bittele Electronics Exhibited at EPTECH 2016
Bittele Electronics Completes New PCB Assembly Line
Bittele strategy climbs turnkey PCB assembly ladder
Bittele Electronics Announces ISO 9001:2008 Certification
Bittele Electronics Sponsors Georgia Tech's Solar Car Engineering Team
Bittele Electronics Offers Free 'Design For Manufacturing' Service to its Customers
Bittele Electronics Introduces New Website for German Customers
Bittele Electronics Sees Double-Digit Growth
Bittele Electronics Adds Quick-Turn Capabilities
 
Sample Bill of Materials (BOM)
Sample Assembly drawings
How to create a Centroid File?
How to Export Gerber Files from Eagle?
Bittele's ISO 9001:2008 Certificate
PCB Fabrication Specifications
 
testimonials
 
payment types
 
 
 
About Us | Services | Quality | Archives | Privacy | Contact
Copyright 2003-2017, Bittele Electronics Inc. All Rights Reserved.